Configuring Wireless Security - Cisco RV315W Administration Manual

Port Management
Configuring Wireless Settings
STEP 3
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
Cisco RV315W Broadband Wireless VPN Router Administration Guide
• Wireless Channel: Choose the wireless channel from the drop-down menu
or choose Auto to let the system determine the optimal channel to use based
on the environmental noise levels for the available channels.
- Select any channel from 1 to 13 channels when the wireless bandwidth
is set to 20 MHz.
- Select any channel from 3 to 11 channels when the wireless bandwidth
is set to 40 MHz (the default is 11 channel).
• Wi-Fi Power: Select the Wi-Fi power on your network. The default value is
High.
• Station Isolation: Check so that the wireless clients on the same SSID will
be unable to see each other.
• Wireless QoS: Check to enable WiFi MultiMedia (WMM), or uncheck to
disable this feature.
Click OK to apply your settings.

Configuring Wireless Security

The RV315W provides four virtual wireless networks.
To configure the settings for a wireless network:
Click Port Settings > WLAN Settings. The WLAN Settings page opens.
The Wireless table displays the following information for a wireless network:
• SSID Name: Name of the SSID.
• Security Mode: Security settings of the SSID.
• Status: Shows whether the SSID is enabled or disabled.
To enable a SSID, check the corresponding SSID and click Enable.
To disable a SSID, check the corresponding SSID and click Disable.
To edit the settings of a SSID, check the corresponding SSID and click Edit.
Enter the following information:
• SSID Name: Enter the name of the wireless network.
4
44