86
2. Instrument cluster
■
The meters and display illuminate when
Vehicles without a smart key system
The engine switch is in the "ON" position.
Vehicles with a smart key system
The engine switch is in IGNITION ON mode.
■
Brightness of the meters (day mode and night mode)
●
The brightness of the meters is changed between day mode and night
mode.
• Day mode: When the tail lights are off or when the tail lights are on but
the surrounding area is bright
• Night mode: When the tail lights are on and the surrounding area is dark
●
When in night mode, the brightness will be reduced slightly unless the
meters are set to the maximum brightness level.
■
Outside temperature display
In the following situations, the correct outside temperature may not be dis-
played, or the display may take longer than normal to change:
●
When stopped, or driving at low speeds (less than 16 mph [25 km/h])
●
When the outside temperature has changed suddenly (at the entrance/exit
of a garage, tunnel, etc.)
●
When "" or "E" is displayed, the system may be malfunctioning.
Take your vehicle to your Toyota dealer.
NOTICE
■
To prevent damage to the engine and its components
●
Do not let the indicator needle of the tachometer enter the red zone, which
indicates the maximum engine speed.
●
The engine may be overheating if the engine coolant temperature gauge is
in the red zone (H). In this case, immediately stop the vehicle in a safe
place, and check the engine after it has cooled completely. (P. 534)