Uninstalling The Light Kit - Hunter M3586-01 Instructions Manual

Uninstalling the Light Kit

• To uninstall the light kit, first carefully remove the globe and bulbs. Detach the lower switch
housing from the upper switch housing. In the lower switch housing, disconnect the black
wire from the blue wire and disconnect the two white wires.
• Remove the reverse switch by unscrewing the two screws on the outside of the lower switch
housing.
• Remove the fan switch by unscrewing the switch nut located under the light kit shroud.
• Install the fan switch assembly into the optional lower switch housing by feeding the pull
chain through the round hole in the side of the optional switch housing. Secure the switch
by installing the switch nut to the threaded barrel on the outside of the switch housing. Hand
tighten the nut in a clockwise direction until snug.
• Install the reverse switch into the optional lower switch housing by aligning the gasket and
reverse switch with the square hole in the side of the optional switch housing then installing
the two screws.
• Once both switches have been installed in the optional switch housing, install the dummy
terminals (included in the sack parts) on the two disconnected wires in the lower switch
housing.
• Repeat the steps on page 15 to install the lower switch housing.
M3586-01 • 11/18/15 • © 2015 Hunter Fan Company
22
www.HunterFan.com
1.888.830.1326