Hunter M3586-01 Instructions Manual page 6

Ceiling Bracket
OFF
Remove all four mounting isolators.
To avoid possible electrical shock, before
installing your fan, disconnect the power by
turning off the circuit breakers to the outlet
box associated with the wall switch location.
Mounting
Isolator
Tapered
Mounting
Holes
Align the tapered mounting holes in the
ceiling plate with the holes in the ceiling bracket.
Install the four ceiling plate screws found in
the hardware bag and secure with the
flange nuts using a .87 cm / 11/32 in wrench.
Hold the ceiling bracket assembly up to the
outlet box and mark the screw locations. To
mount to support structure, also mark the
ceiling for drilling pilot holes.
6
M3586-01 • 11/18/15 • © 2015 Hunter Fan Company
Ceiling Plate
Ceiling
Screws Plate
Ceiling
Gasket
Plate
Flange
Nuts
Ceiling
Plate
Ceiling
t
Bracke
Install the ceiling plate gasket onto the
ceiling plate. The four holes in the ceiling
plate should line up with the four posts
www.HunterFan.com
1.888.830.1326
Post
in the gasket.
Refer to warning w.1 on pg. 2