Table of Contents
Advertisement
Remote Control
Battery
Door
Phillips
Head
Screw
To access the battery compartment, remove
the small Phillips head screw that secures the
battery door to the transmitter assembly. Install
one (1) 3-Volt, CR2032 battery (included) into the
transmitter. Clean the battery contacts and also those
of the device prior to battery installation. The battery
should be installed with the positive (+) side up.
Please contact your local battery recycling center for
proper battery disposal information.
This product contains a button battery. If swallowed,
it could cause severe injury or death in just two hours.
Seek medical attention immediately.
CAUTION:
• Always purchase the correct
size and grade of battery most
suitable for the intended use.
• Replace all batteries of a set at
the same time.
• Clean the battery contacts and
also those of the device prior to
battery installation.
• Ensure the batteries are
installed correctly with regard to
polarity (+ and -).
• Remove batteries from equipment
which is not to be used for an
extended period of time.
• Remove used batteries promptly.
18
18
M3586-01 • 11/18/15 • © 2015 Hunter Fan Company
www.HunterFan.com
ON
The remote transmitter should already be paired
to the receiver and ready to use.
Note: If your need to pair your remote, cycle
power to the fan by turning power off and
back on at the wall switch (or circuit breaker if
necessary). Within three minutes, press and hold
both the Fan Off button and the 4 button for four
seconds to pair the remote. To prevent faulty
operation, please disconnect power from all
other ceiling fans within range while pairing.
1.888.830.1326
Advertisement
Table of Contents
