Check Hydraulic Fluid - Gravely Compact-Pro 34 991088 Operator's Manual

Install Battery
1. Replace battery and secure with battery
hold down.
2. Reconnect cables to battery (positive,
then negative). Position boot over
positive terminal.
3. Return seat to operating position.
Clean Battery
1. Remove battery from unit. See Remove
Battery on page 19.
2. Clean terminals and battery cable ends
with a wire brush.
3. Coat terminals with dielectric grease or
petroleum jelly.
4. Reinstall battery. See Install Battery on
page 20.
Charge Battery
Check battery with a voltmeter. If battery is
less than 11 volts, charge battery.
IMPORTANT: DO NOT fast charge. Charging
at a higher rate damages or destroys the
battery. ONLY use an automatic charger
designed for use with your battery.
IMPORTANT: Always follow information
provided on battery by battery manufacturer.
Contact battery manufacturer for detailed
information about charging.
IMPORTANT: Gravely does not recommend
jump starting your unit. Jump-starting can
damage engine and system components.
Refer to engine manual for detailed
information.
1. Remove battery from unit. See Remove
Battery on page 19.
2. Place battery on bench or other well-
ventilated area.
3. Connect positive lead of charger to
positive battery terminal.
4. Connect negative lead of charger to
negative battery terminal.
5. Charge battery following battery
manufacturer's instructions.
6. Reinstall battery. See Install Battery on
page 20.

CHECK HYDRAULIC FLUID

See Figure 19.
WARNING: HYDRAULIC FLUID
can result in severe burns. Fluid
in hydraulic system can
penetrate skin and result in
serious injury or death.
Be sure to stop the engine
before doing any work on
hydraulic parts.
Keep body and hands away
from pin holes or nozzles which
expel hydraulic fluid when under
pressure. Use paper or
cardboard, not hands, to search
for leaks.
Ensure all hydraulic fluid
connections are tight and all
hydraulic hoses and lines are in
good condition before applying
pressure to system.
FOREIGN FLUID INJECTED
INTO BODY can result in
gangrene. Fluid must be
surgically removed within a few
hours by a doctor familiar with
this form of injury.
Operating
Range
1. Start the unit and run it to operating
temperature (about 10 minutes).
2. Cycle the control levers forward and
backward two or three times.
3. For units equipped with a hydraulic deck
lift, raise and lower the deck completely
two or three times.
4. Shut OFF engine. Engage parking brake.
Remove the ignition key.
5. Put seat in service position. See
Figure 17.
6. Remove any dirt that may be around the
cap/dipstick on the hydraulic reservoir.
7. Remove cap/dipstick.
8. Check hydraulic oil level mark on
cap/dipstick.
EN - 20
FULL Mark
Figure 19