Steering Control Neutral Adjustment - Gravely Compact-Pro 34 991088 Operator's Manual

4. Turn the eccentric spacer until the right
and left handles are the same height.
Tighten nut.
Adjust Steering Levers
See Figure 24.
1. Shut OFF engine. Engage parking brake.
Remove the ignition key.
2. Place seat in the service position. See
Figure 17.
3. Loosen damper locknut on the same side
as the steering lever to be adjusted.
4. Loosen brake interlock on the same side
as steering lever to be adjusted.
5. Loosen tie rod jam nut and turn tie rod
until steering levers are aligned.
6. Tighten jam nut on tie rod, tighten brake
interlock and tighten damper locknut.
1
2
7
7
1. Damper Locknut
2. Damper
3. Tie-Rod Jam Nut
4. Tie-Rod
5. Steering Lever
6. Brake Interlock
7. Hydrostatic Transmission
Figure 24
5
4
3
3
STEERING CONTROL NEUTRAL
ADJUSTMENT
See Figure 25.
1. If hydraulic system is cold, run unit for a
minimum of five minutes, then shut OFF
engine.
2. With the unit up to and facing a wall, jack
up the unit so that both drive wheels are
off the ground.
3. Remove the drive wheels from the unit.
4. Start the engine, run engine at full throttle,
and release the parking brake.
5. Move the steering levers from Forward to
Reverse several times to make sure
controls are free. Then return steering
levers to neutral position.
6. Check wheel(s) for movement.
NOTICE: The right and left hydraulic pumps
are adjusted the same way.
7. If a wheel moves, adjust the return to
neutral mechanism on the hydraulic
pump:
a. Loosen the set screw on the pump.
6 b. Slowly move the stop bracket
clockwise or counterclockwise until
the wheel stops moving.
c. Hold the stop bracket in position and
tighten the set screw on the pump.
8. Move steering levers from Forward to
Reverse several times and return
steering levers to neutral position. Check
wheel(s) for movement.
9. If wheel is still moving, repeat steps 7 and
8.
10. Shut OFF engine.
11. Replace drive wheels.
EN - 23
WARNING: This adjustment
requires operating the engine.
Use extreme care to avoid
contact with moving parts and
hot surfaces. Be sure rear of unit
is well supported and secure
before starting engine.