Chapter 1. Receipt Of Equipment And Installation; Section 1. Receipt Of Equipment - Hobart GPU-600 Operation And Maintenance Manual

OM-2010
CHAPTER 1. RECEIPT OF EQUIPMENT
AND INSTALLATION

SECTION 1. RECEIPT OF EQUIPMENT

Check the equipment received against the Hobart Brothers Company invoice to make certain that the
shipment is complete and undamaged. If the equipment has been damaged in transit, notify the carrier
(railroad, trucking company, etc.) at once and file a claim for damages. If you require assistance with a
damage claim, furnish Hobart Brothers Company with full information about the claim. If the shipment is in
error, contact Order Department, Hobart Brothers Company, Power Systems Division, Troy, Ohio 45373.
Give the MODEL, SPECIFICATION, and SERIAL numbers of the equipment, and a full description of the
parts in error. Refer to the title of this manual for a listing of the specification numbers this manual describes.
An identification and rating nameplate is normally located on the power supply front panel for your
convenience. If the rated input or output voltages do not agree with your requirements, contact the order
department for instructions or corrective action.
Generally, it is good practice to move the equipment to the site of installation before uncrating or unpacking .
Take care to avoid damage to the equipment if bars, hammers, etc., are used. Lifting eyes which extend
through the top of the cabinet have been provided to facilitate handling with a crane or hoist. Be certain the
crane or hoist is adequate for the task.
Best results will be obtained with this equipment ONLY if the responsible operating personnel have access to
this manual, and are familiar with these instructions. Additional copies may be obtained at a small cost per
copy by writing to: Hobart Brothers Company, Power Systems Division, Troy, Ohio Supply the owner's
manual no. (OM-2010) plus the model, specification, and serial numbers of your equipment.
April 10/89 Revised 1-1
Page 1