Telephone Operations; Basics - Clarity C460 User Manual

Answering Calls
To answer a call press TALK.
To end the call press END.
Press FLASH during a call to answer a second call. (If you have call waiting service)
note: If AUTOTALK is on, simply remove the handset from the base to answer
and place back into the base to end the call. To set this up, see page 25.
Making Calls
To make a call, press TALK, and then dial the number. The number may also be
dialed first, using the Clear (CL) button to clear any mistakes. After the number is
entered, press the TALK key to activate the line and dial the number.
To end a call, press END.
Speakerphone
To use the speakerphone function, press SPEAKER to answer the incoming calls. To
make an outgoing call, press SPEAKER and then dial the number. To change back for
normal handset use, press Speaker again. To end call, press END.
booST on/off
The BOOST button controls the loudness of the receiver. This button is located
on the side of the handset and on the base. Once the BOOST button is pressed, an
extra level of amplification is added over the entire range of volume control.
Volume Control
During a call, the up and down arrows below the screen on the handset control the
volume level for the handset. The arrows on the base control the volume of the
Speakerphone. The volume has a maximum level of 16dB before the BOOST button
is activated. Once the BOOST button is pressed, the C460 will provide up to 40dB
of amplification.
Help button
This button can be used to speed dial a preprogrammed number. This number
must be programmed by user. Once a number is stored and the button is pressed,
the phone will dial the pre-programmed number and automatically enable the
16

TELEPHonE oPErATionS

bASiCS