Replacing The Console Batteries; Checking The Belt Tension - Schwinn IC3 Assembly And Owner's Manual

Replacing the Console Batteries

When the batteries are low on power, the console display contrast will dim.
When replacing the batteries, make sure the batteries point in the +/- direction shown in the battery bay.
Note: The console uses AA size alkaline batteries (SUM3)
Do not mix old and new batteries.
!
Do not mix alkaline, standard (carbon-zinc), or rechargeable (Ni-Cd, Ni-MH, etc) batteries.
Be sure to remove the batteries to prevent corrosion damage if you are not going to use the machine for an extended
period of time.
Checking the Drive Belt Tension
To test the Drive Belt tension, sit on the bike and use the pedals at approximately 20 RPM. Then accelerate quickly
(speed burst) to your maximum ability and feel whether the Drive Belt slips. If the pedals move normally with no skipping
(slip), the tension is correct. If the Drive Belt slips, refer to the "Adjust the Belt Tension" procedure in the Service Manual.
X2
+
-
23