Advertisement
Step 3
XN13
(30)
The roof beams join the two gables
and support the roof panels. The
main roof beam is made up of four
pieces overlapped back to back at
the center. The left and right roof
beam assemblies are made up of
two pieces.
Hint: These pieces are force-fi tted,
so you may have to press hard to join
them together.
1
Place one end of a roof beam in-
side another roof beam so that the six
holes in each piece align. Make four
sets of roof beams by repeating this
procedure. Do not insert bolts yet.
2
Take two of the pressed-together
roof beams and join them as shown
to form the main roof beam assem-
bly. Hold the assembly together and
fasten with 14 bolts. Build only one
Doubled Beam Assembly.
3
Fasten the other two pressed-
together roof beams with eight bolts
to make the left and right roof beam
assemblies.
4
Double check the length of each
and set these pieces aside for later
use.
Parts Needed For
Roof Beam Assemblies
10397
STEP
1
STEP
2
STEP
3
Build two Single Beam
Assemblies
16
Assembled
End
View
Build one Doubled Main Roof
Beam Assembly for Peak in Roof
142 3/8"
361,6 cm
10397 Roof Beam (8)
10397
142 3/8"
361,6 cm
142 3/8"
361,6 cm
Advertisement
