Comtech EF Data C Installation And Operation Manual page 19

HPOD
System Operation
The DC prime power input connector, J10, is a 4-pin circular connector. A mating
connector (CA3106E2222SB, CEFD PN CN/CA3106E2222SB) is provided. The pin-out
specifications for J10 and its mate are contained in the table below.
Pin
A
B
C
D
Mating connector: CA3106E2222SB, CEFD PN CN/CA3106E2222SB
2.1.4 C
ONNECTOR
WARNING
The prime power input requirements are
The AC prime power input connector, J3, is a 3 pin circular connector, type CA3102E20-
19PB FMLB A. The ground pin A, is of the first make, last break type. A mating
connector (CA3106E20-19SB) is provided. The pin-out specifications for J3 and it's
mate are contained in the table below.
Table 2-2. Connector J10 Pinout
Description
V+
No Connect
No Connect
V-
J3: AC P
OWER
Before applying AC power to the unit, make sure the waveguide output of the
amplifier is properly loaded or terminated. Failure to do so could lead to
equipment damage and excessive RF radiation levels.
• 180-264 VAC
• 47 to 63 Hz
• The power supply is power factor corrected. The total power required
from the prime power supply depends on the model used. Please refer
to the respective data sheets.
Table 2-3. Connector J3 Pinout
Pin
A
B
C
M
AINS
Description
Ground
L2
L1
2–3
Revision 2