JVC KD-SH77R Service Manual page 8

KD-SH77R/KD-SH55R
6. Remove the two screws L and move the main board
backwards to release the two joints a. (The main
board will be removed with the rear panel and the
rear heat sink)
7. Remove the screw M and N attaching the rear heat
sink.
8. Remove the two screws O
attaching the rear panel. Remove the mainboard
(KD-SH55RE).
9. Remove the three screws O
attaching the rear panel. Remove the main board
(KD-SH77RE).
O
P N
Rear panel
Fig.15 (KD-SH77RE)
Removing the lifter switch board
Prior to performing the following procedures, remove
the top chassis, the motor bracket and the main
board.
1. Remove the two screws Q attaching the lifter switch
board.
1-8
and the screw P
and the screw P
M
Rear heat sink
(See Fig.16)
Lifter switch board
Joint a
Joint a
Fig.14
O
P
N
Rear panel
Fig.15 (KD-SH55RE)
Q
Fig.16
Main board
M
Rear heat sink
Bottom cover