JVC KD-SH77R Service Manual page 7

Removing the main board
Prior to performing the following procedures, remove
the top chassis and the motor bracket.
1. Disconnect the flexible wire from connector CN701
and CN702 on the main board respectively.
2. Move the front bracket backward until it stops.
3. Remove the four screws J
brackets (L) and (R). Move the right and arm lefter
brackets from the rod gear.
4. Remove the rod gear.
5. Remove the screw K attaching the rear panel to the
bottom cover on the back of the body.
Rear panel
Fig.13 (KD-SH77RE)
(See Fig.11 to 15)
attaching the arm
K
Bottom cover
L
Main board
J
Arm
brackets (L)
J
CN702
CN701
Arm brackets (L)
Arm brackets (R)
Rod gear
Rear panel
Fig.13 (KD-SH55RE)
KD-SH77R/KD-SH55R
L
Arm
brackets (R)
Rod gear
Fig.11
Main board
Fig.12
K
Bottom cover
J
1-7