Using The Alarms And Hourly Time Signal; Stopwatch Mode - Casio QW-3329 Operation Manual

Using the Alarms and Hourly Time Signal

You can set the daily alarms in 1-minute increments. The watch
beeps for 10 seconds when the current time in the Timekeeping
Mode reaches the alarm time you set.
The Hourly Time signal causes the watch to beep every hour on
the hour.
❚ To display the alarm screen
In the Alarm Mode, press the D D D D button to toggle the display D
between the alarm screen and the Hourly Time Signal
screen.
When you enter the Alarm Mode, the screen that was displayed
when you last exited the mode appears first.
Alarm Screen Hourly Time Signal Screen
• Alarm off • Hourly Time Signal off
❚ To turn the alarm on or off
1.
In the Alarm Mode, use the D D D button to display the D D
alarm screen.
2.
Press the A A A A A button to toggle the alarm on ("
displayed) or off (" " displayed).
Alarm Off Alarm On
Alarm Time
❚ To stop the alarm beeper
Press any button.
❚ To test the alarm
In the Alarm Mode, hold down the D button to sound the alarm.
Operation Guide 3329
❚ To set the alarm time
1.
In the Alarm Mode, press
the D D D D button to display D
the alarm screen.
2.
(Setting Screen)
A A
Hold down the A A A button
for about two seconds.
• This will cause the hour digits
of the displayed alarm time to
flash.
• Displaying the setting screen
automatically turns on the
alarm.
❚ To turn the hourly time signal on or off
1.
In the Alarm Mode, use the D D D D button to display the D
Hourly Time Signal screen.
2.
Press the A A A button to toggle the Hourly Time Signal on A A
"
(" ") or off (" ").
Hourly Time Signal Off Hourly Time Signal On
3.
D D D (+) and B
Use the D D
buttons to change the
hour setting.
• Holding down either button
changes the setting at high
speed.
• When setting the hour, make
sure you specify AM (no
indicator) or PM (P) correctly
when using 12-hour
timekeeping, or that you
specify the correct 24-hour
time.
• The same 12-hour/24-hour
format you select for the
Timekeeping Mode home time
is also applied in the Alarm
Mode.
4.
C C
Press the C C button to C
select the minute setting.
Hour
• This causes the minute digits
to flash.

Stopwatch Mode

The stopwatch measures elapsed time in units of 1/100 second up to 59 minutes, 59.99 seconds (60 minutes total). When the maximum
limit is reached, the elapsed time automatically returns to zero and timing continues from there.
❚ To perform elapsed time measurement
In the Stopwatch Mode, press the D
elapsed time measurement.
(Split/Reset)
(Back) 5.
B B (–) B
B Use the D
buttons to change the
minute setting.
• Holding down either button
changes the setting at high
speed.
(Forward)
6.
When the setting is the way you want, press the A
button.
• This exits the setting screen.
• The display also will exit the setting screen automatically if
you do not perform any operation for about two or three
minutes.
Minutes
❚ Stopwatch Mode Display Screens
• Elapsed Time Screen
D D D D button to start and stop
The display shows the minutes and seconds.
(Start/Stop)
• Paused Elapsed Time Measurement Screen
When elapsed time measurement is paused, the display alternates
between a minute/second screen and a 1/100 second screen at
2-second intervals.
Minutes
(Back)
D D (+) and B D B (–) B B
D B
(Forward)
A A
A A
Minutes Seconds
2-second
interval
Seconds 1/100 Second
6