Before You Call For Service - Fisher & Paykel WH2424F Installation Instructions And User Manual

User warnings
Your washer is capable of diagnosing a number of its own problems. In most cases,
your washer will sound a continuous series of beeps and display a code when it has a
problem that you can correct yourself. All control panel lights will turn off and the code
will be displayed to inform you what the problem is. To stop the beeps, press any button
on the control panel. Do not try to continue washing once you stop the noise. You must
address the problem the washer is alerting you to.
Check this chart before you call for service.
PROBLEM
Keylock is
activated
Pump filter is
blocked
Water is not
getting to the
machine
Wash load
is out of
balance
40

BEFORE YOU CALL FOR SERVICE

DISPLAYED AS WHAT TO DO
Touch and hold the 'Keylock' button for 2 seconds.
Clear the pump filter (refer to page 38).
Check the faucets have been turned on.
Check the hose connections. If the cold water
supply is connected to the hot valve and there is no
connection to the cold valve the machine will not fill.
Check the inlet hose filters are not blocked, the
hose(s) are not kinked and are attached correctly.
Check that the drain hose is not too low or pushed
into the standpipe too far. This will cause the water to
siphon out of the machine.
Check the water flow rate. It maybe too low.
Touch
If the out of balance persists, pause the cycle,
manually redistribute the load and touch
again. If necessary, stop the cycle, select 'Spin' and
touch
If the problem persists, check the machine is correctly
leveled.
to try the spin again.
.
to spin