Before You Call For Service - Fisher & Paykel WD8560F1 Installation Instructions And User Manual

User warnings
Your washer dryer is capable of diagnosing a number of its own problems. It will sound
a continuous series of beeps and display a code when it has a problem that you can
correct yourself. All control panel lights will turn off and the code will be displayed to
inform you what the problem is. To stop the beeps, press any button on the control
panel. Do not try to continue washing or drying once you stop the noise. You must
address the problem the washer dryer is alerting you to.
Check this chart before you call for service.
PROBLEM
Water is not
getting to the
machine.
Wash load
is out of
balance.
Too many
suds.
40

BEFORE YOU CALL FOR SERVICE

DISPLAYED AS WHAT TO DO
Check the tap has been turned on.
Check the hose connection.
Check the inlet hose filter is not blocked, the hose is
not kinked and is attached correctly.
Check that the drain hose is not too low or pushed
into the standpipe too far. This will cause the water to
siphon out of the machine.
Check the cold water temperature does not exceed
the 35°C temperature requirement.
Check the water flow rate. It maybe too low.
Touch
If the out of balance persists, pause the cycle,
manually redistribute the load and touch
again. If necessary, stop the cycle, select 'Spin' and
touch
If the problem persists, check the machine is correctly
levelled.
Machine will stop and flash
for suds to dissipate. The machine will not beep
during this time. When the suds have dissipated, the
machine will automatically restart.
If a suds event has occurred during a cycle the
machine will also display this warning at the end of
the cycle, to alert you that this has occurred. This may
help to explain any reduction in performance.
Check you are using a suitable detergent.
Check you are not overdosing the detergent.
Check the standpipe height for the drain does not
exceed 1200mm.
to try the spin again.
.
to spin
while waiting