Fisher & Paykel WD8560F1 Installation Instructions And User Manual page 23

Time to go
Your washer dryer displays approximately how many minutes are
remaining in the cycle you are running, so that you can tell at a
glance when your laundry will be finished. Please be aware that a
number of factors can influence the overall cycle time, eg the water
flow rate, water pressure, load size, cycle, fabric type of garments,
wetness of the load and options selected. Therefore, cycle times
will vary, even during a cycle. Unexpected events in a wash cycle
(eg out of balance, oversudsing) can lengthen the cycle time.
Wash and dry options
This button controls the functionality of your washer dryer. If you
are wanting to perform an individual wash only cycle please select
'Wash'. If you are wanting a continuous wash and dry cycle please
select both 'Wash' and 'Dry'. This cycle will seamlessly continue from
wash to dry so your washing is completed in one easy step. If you
are wanting to perform an individual drying cycle please select 'Dry'.
Wash only
If performing a wash only cycle, the approximate wash time will be
displayed and will count down until cycle completion.
Dry only
If performing a dry only cycle (eg 'Everyday', 'Cottons', 'Heavy',
'Delicate', 'Synthetic', 'Towels' or 'Allergy') the machine will display
until the washer dryer has determined the time it will take
to dry each specific load.
of minutes the cycle you are running has remaining. Once your
washer dryer has achieved the dryness setting you have selected,
it will go into a cool down phase and display
reaches a safe temperature, and then ends the cycle. In some cases
when running a dry only cycle the machine will display
will not calculate a remaining time to go. This is normal and can
occur due to a number of different factors, ie running back to back
drying cycles.
If you have chosen an 'Air Dry' cycle, your washer dryer will display
a time to go until the end of the cycle is reached. If you select a
'Time Dry' cycle the machine will display the time to go until the
down period is reached and the cycle ends.
Wash and dry
If performing a continuous wash and dry cycle your machine will
display an estimated cycle time. The time depends on the cycle
and options chosen, and the average time to dry a typical load
size is added to the wash time. Once the wash cycle has finished
the machine will display
depending on a number of factors. The estimated time to go will
then be displayed until the cool down phase begins.
WASHER DRYER CONTROLS
will be replaced by the number
and recalculate the drying time
Wash and dry options
until the load
and
Time to go
Wash only cycle
Dry only cycle
Wash and dry cycle
21