Fisher & Paykel WD8560F1 Installation Instructions And User Manual page 12

To remove the bolts:
Use a spanner or socket to unscrew and remove all four transit bolts at the back of the
1
washer dryer (A).
Pull the black rubber grommets to remove the bolt, grommet and white plastic spacers
2
from the machine. Keep the transit bolts in case they are required for future transit of the
machine. Never transport the machine without the transit bolts properly fixed in place.
Cover the bolt holes with the white plastic plugs which are attached to the machine and
3
located near each hole (B). Push to clip into place.
A
Removing the transit safety bolts
Installation location
IMPORTANT!
The washer dryer must be installed in a well-ventilated, dust-free environment.
● ●
The washer dryer must not be installed on any textured floor coverings (eg carpet,
● ●
rugs) to ensure that openings at the base of the machine are not obstructed.
Do not install the washer dryer behind a lockable door, sliding door, or behind a door
● ●
where the hinge is on the opposite side to that of the washer dryer in such a way that
the full opening of the door is inhibited. Ensure the washer dryer door can always be
opened fully.
Note: this washer dryer CANNOT BE INVERTED AND MOUNTED ON THE WALL.
10
INSTALLATION INSTRUCTIONS
B