Step 14: Connecting the electrical power
Turn off the electricity to the dishwasher's electrical circuit.
Skip this step if your dishwasher is equipped with a power cord.
Make sure that the electrical power is turned off at the source.
1 Remove the junction box cover from the power supply junction box on the wall.
Junction box
2 Locate the three dishwasher wires, (white, black, and green) with stripped ends, then insert the dishwasher
wires through the small hole in the junction box.
3 Secure the house wiring to the bottom of the junction box with a strain relief fitting.
4 Use wire nuts to connect incoming ground to green, white to white, and black to black.
5 Replace the junction box cover. Make sure that no wires are pinched under the cover.
You'll need:
Phillips screwdriver
Ground to green
Strain relief (for
electrical connections)
www.insigniaproducts.com
Top Control Dishwasher
Warning
• If your house wiring is not 2-wire
with a ground, a ground must be
provided by the installer.
• If your house wiring is aluminum, be
sure to use cUL/UL Listed
anti-oxidant compound and
aluminum-to-copper connectors.
White to white
Black to black
Insert wires through strain relief fitting and tighten
Wire nuts (UL listed)
21