Step 12: Connecting The Water Supply Line - Insignia NS-DWH2BS8 Installation Manual

NS-DWH2BS8/NS-DWH2SS8/NS-DWR2BS8/NS-DWR2WH8/NS-DWR2SS8

Step 12: Connecting the water supply line

1 Slide the compression nut, then the ferrule over the end of the water supply line.
2 Insert the water supply line into the 90° elbow.
3 Slide the ferrule against the 90° elbow and secure it with the compression nut.
Ferrule
Water supply line Compression nut
90° elbow
IMPORTANT:
Make sure that the door spring does not rub or contact the water supply line or drain
hose. Test by opening and closing the door. Reroute the lines if interference occurs.
You'll need:
Adjustable wrench
Waterline kit
Teflon thread seal tape
18
www.insigniaproducts.com