Step 4: Install The Power Cord; Step 5: Install The 90° Water Supply Elbow - Insignia NS-DWH2BS8 Installation Manual

Step 4: Install the power cord

Skip this step if the dishwasher will be direct wired.
1 Remove the junction box cover on the right front of the dishwasher.
2 Connect the incoming white (or ribbed) wire to the dishwasher's white wire, the black (or smooth) wire to the
dishwasher's black wire, and the ground wire to the dishwasher's green wire. Use cUL/UL listed wire nuts of
the appropriate size.
3 Replace the junction box cover on the right front of the dishwasher. Be sure that the wires are not pinched
under the cover.
Remove the junction
box cover
Step 5: Install the 90° water supply elbow
1 Wrap the male thread of the 90° elbow with Teflon thread seal tape. Do not use plumber's putty.
2 Install the 90° elbow onto the water valve. Do not overtighten the 90° elbow. The water valve bracket could
bend or the water valve fitting could break.
3 Position the end of the elbow to face the bottom right side of the dishwasher.
You'll need:
Phillips screwdriver
12
NS-DWH2BS8/NS-DWH2SS8/NS-DWR2BS8/NS-DWR2WH8/NS-DWR2SS8
Wire nuts (UL listed)
Power cord
www.insigniaproducts.com
Black wire to black (hot)
wire
White wire to white
(neutral) wire
Green wire to green
(ground) wire
Adjustable wrench
90° elbow
Teflon thread
seal tape