Step 2: Adjust The Leveling Legs - Insignia NS-DWH2BS8 Installation Manual

Step 2: Adjust the leveling legs

1 Move the dishwasher close to the installation location and lay it on its back.
2 Measure the installation height and the dishwasher height.
3 Extend the leveling legs out from the dishwasher base 1/4 in. (6.35 mm) less than the installation height.
Adjust to 1/4 in. (6.35 mm)
less than the installation
height.
Step 3: Remove the toekick
• Remove the two toekick screws with a Phillips screwdriver, then remove the toekick.
You'll need:
Adjustable wrench
www.insigniaproducts.com
Top Control Dishwasher
Adjust to 1/4 in. (6.35 mm)
less than the installation
height.
Phillips screwdriver
11