Step 12: Connecting The Water Supply Line; Step 13: Connecting The Drain Hose - Insignia NS-DWH2BS8 Installation Manual

NS-DWH2_BS8_SS8_NS-DWR2_BS8_WH8_SS8_17-0939_Install MAN_V5_ENG.fm Page 19 Wednesday, January 24, 2018 2:49 PM

Step 12: Connecting the water supply line

1 Make sure that you wrapped the 90° elbow with Teflon thread seal tape twice.
2 Slide the compression nut, then the ferrule over the end of the water supply line.
Note:
If you have a steel-grated line, you do not need a ferrule or compression nut.
3 Insert the water supply line into the 90° elbow.
4 Slide the ferrule against the 90° elbow and secure it with the compression nut.
Back of dishwasher
IMPORTANT:
Make sure that the door spring does not rub or contact the water supply line or drain hose. Test by opening and
closing the door. Reroute the lines if interference occurs.
You'll need:

Step 13: Connecting the drain hose

IMPORTANT:
Follow all local codes and ordinances.
1 Cut on the marked line as required for your installation. The drain hose's molded end will fit 5/8", 3/4" or 1" diameter
connections on the air gap, waste tee, or garbage disposal.
Two wraps of Teflon
thread seal tape
90° elbow
Adjustable wrench
Hot water line kit
Cutting lines
www.insigniaproducts.com
NS-DWH2BS8 / NS-DWH2SS8 / NS-DWR2BS8 / NS-DWR2WH8
Ferrule
Water supply line
Teflon thread seal tape
IMPORTANT: Do not cut
corrugated portion of hose
Compression nut
19