Table of Contents
Advertisement
27 MCGAIN
Function: Adjust the microphone gain level.
Available Values: 1 - 9
Default: 5
28 MEM.SCN
Function: Selects the Memory Scan mode.
Available Values: TAG1 / TAG2 / ALL CH
Default: ALL CH
ALL CH: The scanner sweeps all Memory channels.
TAG1:
The scanner sweeps only those Memory channels with the same "first" digit of
the alpha/numeric tag as the first channel on which scanning started.
TAG2:
The scanner sweeps only those Memory channels with the same "first" and
"second" digits of the alpha/numeric tag as the first channel on which scanning
started.
29 MW MD
Function: Selects the method of selection of channels for Memory Storage.
Available Values: NEXT / LOWER
Default: NEXT
Stores the data into the memory channel which is next-highest from the last-
NEXT:
stored memory channel.
LOWER: Stores the data into the lowest-available "free" channel.
30 NM SET
Function: Programming an Alpha/Numeric label for a Memory Channel.
See page 33 for details.
31 OPN.MSG
Function: Selects the Opening Message that appears when the radio is powered on.
Available Values: DC / MSG / OFF
Default: DC
DC:
DC supply voltage
MSG: Set by user. See below.
OFF: No Opening Message
Here's how to program the Opening Message:
1. Set this Set Mode Item to "MSG".
2. Press the [ LOW ( A/N )] key momentarily to enable programming of the opening mes-
sage. You will notice the first character entry's location blinking.
3. Rotate the DIAL knob to select the first letter/number of the message, then press the
[ LOW ( A/N )] key momentarily to save the first letter/number and move on to the next
character.
4. Repeat the previous step as necessary to complete the message (up to six characters).
5. If you make a mistake, press the [ DW ( REV )] key to back-space the cursor; now
re-enter the correct letter/number.
6. When you have entered the desired opening message, press the [ MHz ( SET )] key
momentarily to confirm the message, then press and hold in the [ MHz ( SET )] key for
one second to save the settings and exit to normal operation.
FT-2980R Operating Manual
"Set" (Menu) Mode
67
Hide quick links:
Advertisement
Table of Contents
