Universal Repeater Mode - Planet Network Device WAP-4033PE User Manual

see a screen to prompt you the settings are save successfully. You may press "Continue" for
configure other settings or "Apply" to restart WAP-4033PE with new configuration.
3.2.7

Universal Repeater Mode

"Universal Repeater Mode" allows you to extend the range of your wireless network. When the
AP is configured to repeater mode, it will repeat the wireless signal from wireless client to
access point. Thus, the wireless connection distance can be extended.
performance will become half of normal performance when client connect to a Repeater.
Besides, when the WAP-4033PE is configured to repeater mode, you can only manage the AP
through LAN interface and the PC(s) connected to its LAN port cannot communicate with other
wireless clients.
Parameter Description
Mode Shows the current operation mode. You may set WAP-4033PE to other operating
mode by select other operating mode.
Band 2.4GHz (B): It allows to select the transmit rate up to 11Mbps.
2.4GHz (G): It allows to select the transmit rate up to 54Mbps.
2.4GHz (B+G): It provides best performance for 11g transmission when you enable
the AP mode selection to "Mixed mode".
SSID The SSID (up to 32 printable ASCII characters) is the unique name identified in a
WLAN. The ID prevents the unintentional merging of two co-located WLANs.
Please make sure that the SSID of all stations in the same WLAN network are the
21
However, the