Parameter Description - Planet Network Device WAP-4033PE User Manual

Parameter Description
Mode Shows the current operation mode. You may set WAP-4033PE to other operating
mode by select other operating mode.
2.4GHz (B): It allows to select the transmit rate up to 11Mbps.
Band
2.4GHz (G): It allows to select the transmit rate up to 54Mbps.
2.4GHz (B+G): It provides best performance for 11g transmission when you enable
the AP mode selection to "Mixed mode".
SSID The SSID (up to 32 printable ASCII characters) is the unique name identified in a
WLAN. The ID prevents the unintentional merging of two co-located WLANs.
Please make sure that the SSID of all stations in the same WLAN network are the
same. The default SSID is "default".
Channel Number Select the appropriate channel from the list provided to correspond with your
network settings. Channels differ from country to country.
Channel 1-11 (North America)
Channel 1-14 (Japan)
Channel 1-13 (Europe)
Associated Clients You may press "Show Active Clients" button to check the connected client
information. After the button pressed, you will see the dialog box as below.
You may press "Refresh" to get the new client table or "Close" to close this dialog
box.
After configuration complete, please click "Apply" button to save the configuration. Then you will
see a screen to prompt you the settings are save successfully. You may press "Continue" for
configure other settings or "Apply" to restart WAP-4033PE with new configuration. This screen
will appear after press the "Apply" button in each configuration screen. When you complete all
the configuration of WAP-4033PE, please press "Apply" of this screen to make the new settings
13