Wireless Monitor - Fortinet Fortigate-5000 series Administration Manual

System Wireless

Wireless Monitor

FortiGate Version 3.0 MR4 Administration Guide
01-30004-0203-20070102
Go to System > Wireless > Monitor to see who is connected to your wireless
LAN. This feature is available only if you are operating the wireless interface in
WPA security mode.
Figure 56: Wireless Monitor (FortiWiFi-60)
Figure 57: Wireless Monitor (FortiWiFi-60A and 60AM)
Statistics
AP Name
Signal Strength (dBm) The strength of the signal from the client.
Noise (dBm)
S/N (dB)
Rx (KBytes)
Tx (KBytes)
Clients
MAC Address
IP Address
AP Name
ID
Statistical information about wireless performance for each
WLAN. Available only on the FortiWiFi-60A and FortiWiFi-
60AM.
The SSID of the WLAN interface.
The received noise level.
The signal-to-noise ratio in deciBels calculated from signal
strength and noise level.
The amount of data in kilobytes received this session.
The amount of data in kilobytes sent this session.
The number of clients connected to the WLAN and
information about each of them.
The MAC address of the connected wireless client.
The IP address assigned to the connected wireless client.
The name of the WLAN to which the client is connected.
Available on the FortiWiFi-60A and FortiWiFi-60AM only.
The user ID of the connected user using WPA RADIUS
security mode. This field is blank if the client uses WPA
Pre-Shared Key or WEP security modes.
Available on the FortiWiFi-60 only.
Wireless Monitor
111