Access Panel; Rack Bezel - HP ProLiant ML350 Maintenance And Service Manual

Remove the foot.
4.
To replace the component, reverse the removal procedure.

Access panel

To remove the component:
Power down the server (on page 26).
1.
Do one of the following:
2.
Extend the server from the rack (on page 26).
•
Remove the tower front bezel.
•
If the locking latch is locked, use a T-15 Torx screwdriver to unlock the latch.
3.
Slide the access panel back about 1.5 cm (0.5 in).
4.
Lift and remove the access panel.
5.
NOTE: Turn the access panel over to locate the hood labels. These labels provide information on installing
various options, flexible memory configurations, LED status indicators, and switch settings.
To replace the component, reverse the removal procedure.

Rack bezel

To remove the component:
Power down the server (on page 26).
1.
Extend the server from the rack (on page 26).
2.
Remove the access panel
3.
("Front bezel" on page 27)
("Access panel" on page 29).
Removal and replacement procedures 29