Hdd Install - Planet 2-Bay SATA NAS RAID Server NAS-7200 User Manual

2.3 HDD Install

The NAS-7200 supports two 3.5-inch Serial-ATA (SATA) hard drives. NAS-7200 does not
support low profile or half high hard drive.
1. Make sure the NAS-7200 is powered off
2. Open rear cover of NAS-7200
3. Make sure your hard drive is SATA interface and make sure you back up all pre-existing
data before use it on NAS-7200
4. To install Disk 1 that located on left side (rear view), make sure HDD top face to left and
connector side in front then slide the HDD into slot
5. To install Disk 2 that located on right side (rear view), make sure HDD top face to right and
connector side in front then slide the HDD into slot
9