Table of Contents
Advertisement
Step 13. Install the Doors
This step describes how to install the front and rear doors on the pSeries 670. For more information about
the doors, see "Prerequisites to Installing the pSeries 670" on page 8.
Note: The upper pin is longer than the bottom pin. The door is made of aluminum for weight reasons.
Install the Front Door
To install the front door, do the following (refer to the illustration on page 20):
Note: After installing the front and rear doors, it may be necessary to adjust the latch.
1. Holding the door vertically and opened at approximately 45 degrees from the frame, lift the door and
carefully engage the top pin into the hinge hole.
2. Continue to hold the door vertically and lift slightly to engage the bottom pin. Before removing your
hands from the door, verify that the pins are engaged in the hinge holes.
3. Position the door so that both the top and the bottom hinge pins (1) partially engage the hinges.
4. Simultaneously slide the top and bottom hinge pins on the front door into the top and bottom hinges
(2) on the rack.
5. Close the front door, and engage the latch on the left side of the door.
6. Remove the protective plastic strip used to protect the decorative copper mylar strip during shipping
and handling.
Note: The copper mylar strip may appear to be scratched or damaged if you don't remove the
protective plastic strip.
Install the Rear Door
To install the rear door, do the following (refer to the illustration on page 20):
1. Position the door so that both the top and the bottom hinge pins (1) partially engage the hinges.
2. Simultaneously slide the top and bottom hinge pins on the rear door into the top and bottom hinges (2)
on the rack.
3. Close the rear door, and engage the latch on the left side of the door.
Chapter 2. Installing the pSeries 670
19
Advertisement
Table of Contents
