Table of Contents
Advertisement
The part numbers for the serial cables for the pSeries 670 are the following:
Part Number and Description
11P3955 6-m cable
11P3956 15-m cable
31L7196 15-m cable
Step 11. What is the Next Step?
The next step in the installation procedure is to apply power to the system and verify that the system is
ready to be used for regular operations. Complete the steps in the checklist in Chapter 4, "Completing the
Installation", on page 27 to verify that the system is ready, and then return to "Step 12. Turn on the IBF
Breaker (If Present)" to complete the installation.
Step 12. Turn on the IBF Breaker (If Present)
Turn on the Integrated Battery Feature (IBF) breaker before turning the UEPO switch on the pSeries 670.
Step 13. Have the Customer Activate the Designated Circuit Breakers
Have the customer activate the designated circuit breakers by doing the following:
1. Ensure that the tag S229-0237, which reads "Do Not Operate," has been removed.
2. Reset the circuit breaker.
Note: The following steps should be performed only by the service representative.
3. Turn the pSeries 670 UEPO switch to the ON position.
4. Verify that the LEDs on the bulk power assembly are on. Verify that OK displays on the pSeries 670
operator panel.
Step 14. Install the Doors
This step describes how to install the front and rear doors on the pSeries 670. For more information about
the doors, see "Prerequisites to Installing the pSeries 670" on page 7.
Note: The upper pin is longer than the bottom pin. The door is made of aluminum for weight reasons.
Install the Front Door
To install the front door, do the following (refer to the illustration on page 18):
Note: After installing the front and rear doors, it may be necessary to adjust the latch.
1. Holding the door vertically and opened at approximately 45 degrees from the frame, lift the door and
carefully engage the top pin into the hinge hole.
2. Continue to hold the door vertically and lift slightly to engage the bottom pin. Before removing your
hands from the door, verify that the pins are engaged in the hinge holes.
3. Position the door so that both the top and the bottom hinge pins (1) partially engage the hinges.
4. Simultaneously slide the top and bottom hinge pins on the front door into the top and bottom hinges
(2) on the rack.
5. Close the front door, and engage the latch on the left side of the door.
Position
9 Position to 9 Position
9 Position to 9 Position
9 Position to 25 Position
Chapter 2. Installing the pSeries 670
17
Advertisement
Table of Contents
