Table of Contents
Advertisement
Multiple System Configurations
The system configuration may vary. Other configurations include multiple HMCs attached to one pSeries
670 and multiple pSeries 670s servers attached to one HMC. For more information, refer to Appendix E,
"Attaching Multiple pSeries 670s to One Hardware Management Console," on page 125.
Prerequisites to Installing the pSeries 670
Before installing the pSeries 670, ensure that the following have been completed:
v Doors have been ordered. The pSeries 670 has the following types of doors:
– Rack Front Door (Universal)
– Rack Rear Door (Slimline)
– Rack Rear Door (Acoustical)
v Planning procedures outlined in Site and Hardware Planning Information, order number SA38-0508, are
complete.
Before You Begin
To ensure that all of the installation steps are complete, the installer should use the following installation
checklist during the installation process:
v "Complete the Installation Checklist" on page 20
Note: If the system you are installing will be managed by an HMC, and the HMC is not installed and
functional, see the IBM Hardware Management Console for pSeries Installation and Operations
Guide, order number SA38-0590, for instructions on installing the HMC. Install the HMC, then return
here to continue with this procedure.
Step 1. Unpack the pSeries 670
Unpack the pSeries 670, and proceed to "Step 2. Check the Inventory" on page 9.
8
Eserver pSeries 670 Installation Guide
Advertisement
Table of Contents
