Table of Contents
Advertisement
Troubleshooting Procedures
The Planar D6015TM Series Medical Monitor was factory adjusted to standard
VGA timing. Due to output timing differences among various VGA cards, you
may initially experience an unstable or unclear display when a new display mode
or new VGA card is selected. This monitor supports multiple VGA modes. Refer
to the "Technical Information" on page 18 for a listing of the factory preset
modes supported.
PROBLEM: No Signal Coming
When the monitor is ON and there is no video signal received, the following
message will be displayed until the monitor enters power-saving mode:
Check to make sure the video cable is attached to the system. Refer to
"PROBLEM: There is No LCD Display" for more information.
PROBLEM: Display is Unclear and Unstable
It is best to adjust the display using an image of vertical lines. In Windows,
load a wallpaper bitmap that has vertical lines in it (or you can select the
Windows shut-down screen).
After you have the wallpaper loaded, open the OSD and select the "Clock"
function. Repeatedly press the upper Adjustment button ( ) until you see
vertical dark and light lines across the screen.
When you can see distinct light and dark vertical bands, repeatedly press and
release the lower Adjustment button ( ) until the distinct bands disappear
and you have a clear display.
Use the Function button (
the horizontal display. Repeatedly press and release the upper Adjustment
button ( ) and you will see horizontal dark and light lines appear.
When you can see distinct light and dark horizontal bands, repeatedly press
and release the lower Adjustment button ( ) until the distinct bands
disappear and you have a clear display.
Operations Manual (OM700-02)
NO SIGNAL COMING...
CHECK SIGNAL CABLE
MONITOR WILL ENTER
POWER SAVING!!!!
or
) to choose the "Phase" function to adjust
23
Advertisement
Table of Contents
