Pan Detection; Residual Heat Indication; Timer - CDA HN7242FR Installation, Use And Maintenance Manual

 Start-up/ switch off the heating zone :
Action
Increase power
Decrease power
Stop
If no selection is made within 20 seconds of turning the hob on, then the hob will turn off.

Pan detection

The pan detection is an extra safety measure. The induction doesn't work:
 If there is no pan on the heating zone or if the pan is not suitable. In this case it is
impossible to increase the power and the display shows [ U ]. This symbol disappears
when a suitable pan is put on the heating zone and is replace by the power level.
 If the pan is removed from the heating zone. The display shows [ U ]. The symbol [ U ]
disappears when the pan is put back on the heating zone. The cooking continues with the
pre-set power level.
After use, make sure that the zones have been switched off: do not leave the pan detection [ U ]
active.

Residual heat indication

After the switching off of a heating zone or turning off the hob, the heating zones may still be hot.
If a zone remains hot then it will display an [ H ] symbol.
The symbol [ H ] disappears when the heating zones have cooled to a safe temperature.
As long as the residual heat indicators are on, do not touch the heating zones and do not put any
heat sensitive objects on them. There are risks of burns and fire. It is advisable to avoid, where
possible, touching the hob surface for some time after cooking.

Timer

The timer is able to be used simultaneously with both heating zones and with different time
settings (from 0 to 99 minutes) for each heating zone.
 Setting and modification of the cooking time
Action
To select the heating zone
To select the power level
To select « Timer »
Decrease the time
Increase the time
After a few seconds the control light stops pulsating and the countdown begins.
The time is confirmed and the cooking starts.
Control panel
Press key [ + ]
Press key [ - ]
Press [ + ] and [ - ] simultaneously
or press [ - ]
Control panel
Press key [ + ] or [ - ]
Press key [ + ] or [ - ]
Press key [ ]
Press key [ - ]
Press key [ + ]
9
Display
[ 4 ] to [ 9 ]
[ 9 ] to [ 1 ]
[ 0 ] or [ H ]
[ 0 ] or [ H ]
Display
[ 4 ] or [ 9 ]
[ 1 ] ... [ 9 ]
[ 00 ] minutes
-1 minute
+1 minute