CDA HN7242FR Installation, Use And Maintenance Manual page 14

5) Take your fingers away from the keys and press again the [ - ] key during a few
seconds until some [ E ] appear.
6) You will hear a "beep" sound and the [ E ] will blink.
7) The [ E ] are automatically transformed into [ C ] → The configuration has been
cancelled.
VI) How to configure the hob?
1) Use a suitable induction pot with a minimum diameter size of 16cm.
2) Select the heating zone by pushing the corresponding [ + ] key.
3) Put the pot on the corresponding heating zone.
4) Wait until [ C ] converts to [ - ]. The zone is configured
5) Use the same procedure for each other heating zone which displays [ C ]
6) The configuration is made if all zones are detected and if nothing is displayed
Use only 1 pot to configure the hob.
Never put two or more pots on the heating zones during the configuration.
 If [ E 4 ] display persists call the After-sales Service
The hob or the cooking zone doesn't start-up :
 The hob is incorrectly connected to the electrical network.
 The protection fuse has cut-off.
 The locking function is activated.
 The touch keys are covered with grease or water.
 An object is covering a key.
The control panel displays [ U ] :
 There is no pan on the cooking zone.
 The pan is not compatible with induction.
 The diameter of the base of the pan is too small.
The symbol [ C ] or [ E ] displays
 Switch the hob off at the mains and then switch it back on.
 Call the After-sales Service
One or all cooking zones have cut-off:
 The safety system activated.
 The cooking zone has been on for a long time.
 One or more touch keys are covered.
 The pan is empty and the base has overheated.
 The hob also has an automatic reduction of power level.
Continuous fan activity after switching off the hob
 This is not a failure, the fan continues in order to protect the electronic devices.
 The fan will stop automatically.
The automatic cooking system doesn't start-up:
 The cooking zone is too hot for the function to engage [ H ]
 The highest power level is set [ 9 ]
 The cooking level was engaged with [ - ]
The control panel displays [
 An object or liquid is obstructing the control keys. The symbol disappears as soon as the
key is released or cleaned.
The control panel displays [ E2 ] :
 The hob has overheated, let it cool and then turn it on again.
] or [ Er03 ] :
14