Setup Menu Features - Lincoln Electric Power Feed 25M Operator's Manual

POWER FEED™ 25M
The Setup Menu gives access to the Setup Configuration. Stored in the setup configuration are user parameters that generally only
need to be set at installation. The parameters are grouped as shown in the following table.
PARAMETER
P.1 through P.99
P.101 through P.199
P.501 through P.509

SETUP MENU FEATURES

Secured Parameters (only accessible through a p.c. or palm application)
SET-UP FEATURES MENU
(See Figure B.17b)
1. To access the set-up menu, press the right and left buttons of
the user interface panel simultaneously. Note that the set-up
menu cannot be accessed if the system is welding, or if there
is a fault (The status LED is not solid green).
Change the value of the blinking parameter by rotating the SET
knob.
2. After changing a parameter it is necessary to press the Right
hand button to save the new setting. Pressing the Left button
will cancel the change.
3. To exit the set-up menu at any time, press the Right and Left
buttons of the MSP4 panel simultaneously.
minute of inactivity will also exit the set-up menu.
FIGURE B.17b - SETUP MENU
Left
button
SET Knob
DEFINITION
Unsecured Parameters (always adjustable)
Diagnostic Parameters (always read only)
Alternately, 1
Main display
Right
button
B-19
OPERATION