Right Trim - HP ProOne 600 G3 Maintenance & Service Manual

Right trim

To remove the right trim:
1. Prepare the computer for disassembly (see
2. Remove the rear port cover (see
3. Remove the stand (see
4. Remove the access panel (see
5. Remove the system board shield (see
6. Remove the top trim (see
7. Remove the four Torx screws (1) that secure the right trim to the computer, and then rotate the trim
away from the computer to remove (2).
To install the right trim, reverse the removal procedures.
50 Chapter 4 Removal and Replacement Procedures
Preparing to disassemble the computer on page
Rear port cover on page
Attaching and removing a stand on page
Access panel on page
System board (EMI) shield on page
Top trim on page 47).
23).
20).
24).
30).
19).