Optional) Configuring Information Output Modes; Establishing The Configuration Task - Huawei S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Device Management
<Quidway> display channel 2
channel number:2, channel name:loghost
MODU_ID
408d0000 QOS
If the information center is correctly configured, you can view information recorded by the
information center by running the display info-center command.
<Quidway> display info-center
Information Center:enabled
Log host:
Console:
Monitor:
SNMP Agent:
Log buffer:
current messages 111, channel number : 4, channel name : logbuffer
dropped messages 0, overwritten messages 0
Trap buffer:
current messages 5, channel number:3, channel name:trapbuffer
dropped messages 0, overwritten messages 0
logfile:
Information timestamp setting:
Sent messages = 10563, Received messages = 10601
IO Reg messages = 0 IO Sent messages = 39
For details about the display, refer to the Quidway S9300 Terabit Routing Switch - Command
Reference.

2.4 (Optional) Configuring Information Output Modes

This section describes how to configure information output modes of the information center.

2.4.1 Establishing the Configuration Task

2.4.2 Outputting Information to the Console
2.4.3 Outputting Information to the Telnet Terminal
2.4.4 Outputting Information to the SNMP Agent
2.4.5 Outputting Information to the Log Buffer
2.4.6 Outputting Information to the Trap Buffer
2.4.7 Outputting Information to the Log Host
2.4.8 Checking the Configuration
2.4.1 Establishing the Configuration Task
Issue 02 (2009-08-06)
NAME ENABLE LOG_LEVEL
Y debugging
channel number : 0, channel name : console
channel number : 1, channel name : monitor
channel number : 5, channel name : snmpagent
enabled,max buffer size 1024, current buffer size 512,
enabled,max buffer size 1024, current buffer size 256,
channel number : 9, channel name : channel9, language : english
log - date, trap - date, debug - boot
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 Information Center Configuration
ENABLE TRAP_LEVEL
Y debugging
ENABLE DEBUG_LEVEL
Y debugging
2-11