Displaying The Interface Status - Huawei S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Device Management
The version of System Management Software (SMS) and the version of the on-board Controller
Area Network bus (CANbus) are displayed.
You can use the command in any view to view the environment version of the S9300.
----End

1.4.10 Displaying the Interface Status

Context
Do as follows on the S9300 whose interface status is to be viewed.
Procedure
l
l
----End
Example
<S9300> display interface GigabitEthernet 2/0/15
GigabitEthernet2/0/15 current state : DOWN
Description:HUAWEI, Quidway Series, GigabitEthernet2/0/15 Interface
Switch Port,PVID :
IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is 0018-2000-0083
Port Mode: FORCE FIBER
Speed : 1000,
Duplex: FULL,
Mdi
Last 300 seconds input rate 0 bits/sec, 0 packets/sec
Last 300 seconds output rate 0 bits/sec, 0 packets/sec
Input:
Unicast:
Discard:
Jumbo
Output: 0 packets, 0 bytes
Unicast:
Discard:
Jumbo
<S9300> display interface vlanif 44
Vlanif44 current state : UP
Line protocol current state : UP
Last up time: 2000-04-03, 06:03:02
Issue 02 (2009-08-06)
Run:
display interface interface-type interface-number
The status of the specified interface is displayed.
Display the current status of an interface.
1. Run:
system-view
The system view is displayed.
2. Run:
interface interface-type interface-number
The interface view is displayed.
3. Run:
display this interface
The current status of the interface is displayed.
100,The Maximum Frame Length is 1526
Loopback: NONE
Negotiation: ENABLE
: NORMAL
0 packets, 0 bytes
0, NUnicast:
0, Error
: 0
0, NUnicast:
0, Error
: 0
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
0
: 0
0
: 0
1 Displaying the Device Status
1-17