Safety Precautions; Location; High Frequency Protection - Lincoln Electric POWER FEED 25M Operator's Manual

®
POWER FEED 25M & 25M ALUMINUM

SAFETY PRECAUTIONS

ELECTRIC SHOCK CAN KILL.
• Turn the input power OFF at the welding
power source before installation or
changing drive rolls and/or guides.
• Do not touch electrically live parts.
• When inching with the gun trigger,
electrode and drive mechanism are "hot"
to work and ground and could remain
energized several seconds after the gun
trigger is released.
• Welding power source must be connected to system
ground per the National Electrical Code or any applicable
local codes.
• Only qualified personnel should perform maintenance
work.
--------------------------------------------------------------------

LOCATION

For best wire feeding performance, place the POWER FEED
on a stable and dry surface. Keep the wire feeder in a vertical
position. Do not operate the wire feeder on an angled surface of
more than 15 degrees.
Do not submerge the POWER FEED
The POWER FEED ® 25M is rated IP23 and is suitable for outdoor
use.
The handle of the POWER FEED
wire feeder about the work place only.
When suspending a wire feeder, insulate the hanging device from
the wire feeder enclosure.
WARNING
® 25M
®
25M.
® 25M is intended for moving the

HIGH FREQUENCY PROTECTION

Locate the POWER FEED
machinery. The normal operation of the POWER FEED
may adversely affect the operation of RF controlled
equipment, which may result in bodily injury or damage to the
equipment.
--------------------------------------------------------------------
A-2
INSTALLATION
CAUTION
®
25M away from radio controlled
®
25M