Remote Control; Hdmi; Ipod Messages - Pioneer VSX1017TXV Operating Instructions Manual

Additional information
12

Remote control

Symptom
Cannot be remote controlled.
Other components can't be
operated with the system remote.
The SR cable is connected, but
the connected components can't
be operated with the remote.

HDMI

Symptom
No picture or sound.
No picture.
OSD does not appear.
No sound, or sound suddenly
ceases.

iPod messages

Symptom
Error I1
Error I2
No Music Track
66
En
Remedy
• Try replacing the batteries in the remote control (see Loading the batteries on page 7).
• Be sure to operate within 7 m (23 feet) and a 30º angle of the remote sensor on the front panel (see
Operating range of remote control unit on page 23).
• Check that there are no obstacles between the receiver and the remote control.
• Make sure that there is no fluorescent or other strong light shining on to the remote sensor.
• Check the connections of the CONTROL IN jack (see Operating other Pioneer components with this unit's
sensor on page 61).
• If the battery ran down, the preset codes may have been cleared. Re-enter the preset codes.
• The preset code may be incorrect. Redo the procedure for entering preset codes.
• Reinsert the SR cable, making sure it's connected to the right jack (see Using this receiver with a Pioneer
plasma display on page 50).
• Make sure that there is an analog or HDMI connection between the units. This is necessary for the SR
feature to work.
• Check that the other component is made by Pioneer. The SR feature only works with Pioneer equipment.
Remedy
• If the problem still persists when connecting your HDMI component directly to your monitor, please
consult the component or monitor manual or contact the manufacturer for support.
• Depending in the output settings of the source component, it may be outputting a video format that can't
be displayed. Change the output settings of the source, or connect using the component, S-video or
composite jacks.
• The OSD will not appear if you have connected using the HDMI output to your TV. Use component, S-video,
or composite connections when setting up the system.
• Since the HDMI audio signal is sent through this receiver to your TV, you need to make separate
connections for audio if you want to hear your HDMI component through this system. See Using SIRIUS
Radio on page 46 for more on this.
• If you've made separate connections for audio, make sure you have assigned the analog/digital jack(s) to
the corresponding HDMI input for the component. See Assigning the HDMI inputs on page 53 to do this.
• Check the audio output settings of the source component.
Cause
There is a problem with the signal path from the
iPod to the receiver.
The software version being used with the iPod
needs to be updated.
There are no playable songs currently stored in
the iPod.
Action
Switch off the receiver and reconnect the iPod to the receiver.
If this doesn't seem to work, try resetting your iPod.
Update the software being used with the iPod (software
versions prior to iPod update 2004-10-20 are not supported).
Input some music files compatible with iPod playback.