Using other functions
10
Dimming the display
You can choose between four brightness levels for the
front panel display. Note that when selecting sources, the
display automatically brightens for a few seconds.
•
Press RECEIVER then press DIMMER repeatedly to
change the brightness of the front panel display.
Switching the speaker impedance
We recommend using speakers of 8 Ω with this system,
but it is possible to switch the impedance setting if you
plan to use speakers with a 6 Ω impedance rating. Use
the front panel controls to do this.
•
With the receiver in standby, press
ON while holding down the SPEAKERS button.
Each time you do this, you switch between the
impedance settings:
• SP 6 OHM – Use this setting if your speakers are
rated at 6 Ω.
• SP 8 OHM – Use this setting if your speakers are
rated at 8 Ω or more.
Resetting the system
Use this procedure to reset all the receiver's settings to
the factory default. Use the front panel controls to do this.
1
Switch the receiver into standby.
2
While holding down the front panel TONE button,
press and hold
seconds.
The display shows RESET?.
3
Press the front panel ENTER button.
The display shows RESET OK?.
4
Press SYSTEM SETUP to confirm.
OK appears in the display to indicate that the receiver
has been reset to the factory default settings.
• Note that all settings will be saved, even if the
receiver is unplugged.
56
En
CD-R/TAPE
CD
iPod
TUNER
RECEIVER
SLEEP
SB ch
ANALOG
ATT
SR+
DIMMER
MIDNIGHT/
LOUDNESS
DIALOG E
PHASE
S.RETRIEVER
D ACCESS
STANDBY/
STANDBY/ON for about three