Using The Quick Setup - Pioneer VSX-D514 Operating Instructions Manual

02 5 minute guide

Using the Quick Setup

You can use the Quick Setup to get your
system up and running with just a few button
presses. The receiver automatically makes
the necessary settings after you have selected
your speaker setup, room size and listening
position.
If you want to make more specific settings,
refer to Choosing your receiver setup on
page 44.
Use the front panel controls for the steps
below.
ADVANCED STEREO/ SIGNAL MIDNIGHT/
SURROUND DIRECT SELECT LOUDNESS SPEAKERS
TENING MODE
DIGITAL IN
MMER
1 If the receiver is off, press
STANDBY/ON to turn the power on.
2 Press QUICK SETUP.
VSX-D714/D814 only – SW DET flashes in the
display while the receiver checks your setup
for a subwoofer. SW YES or SW NO confirms
the subwoofer check, then the display
prompts you to select your speaker setup.
3 Use the MULTI JOG dial to choose your
speaker setup.
VSX-D714/D814 – When a subwoofer was
detected in step 2, you can cycle between the
following choices:
2.1ch
7.1ch*
6.1ch
12
En
ENTER
MASTER VOLUME
MULTI JOG
SB CH
TONE QUICK SETUP
MODE
DOWN
VIDEO INPUT
S-VIDEO VIDEO L AUDIO R
3.1ch
5.1ch
* VSX-D814 only
If a subwoofer wasn't detected in step 2, you
can cycle between the following choices:
7.0ch*
* VSX-D814 only
VSX-D514 – Cycle between the following
choices:
2.0ch
MULTI JOG
• Check the table below to find the speaker
UP
setup that corresponds with your system.
* VSX-D714/D814 only
** VSX-D814 only
4.1ch
2.0ch 3.0ch
6.0ch 5.0ch
5.1ch 5.0ch 4.1ch
2.1ch 3.0ch 3.1ch
4.0ch
4.0ch