Setting The Relative Volume Level Of Each Channel - Pioneer VSX-D41 Operating Instructions Manual

Setting up the receiver
Setting the relative volume level
of each channel
• Default setting: 0 dB
For best surround sound playback, you should
set the relative channel levels from the main
listening position. You can set seperate levels
for each surround mode.
1 Press STANDARD.
2 Press TEST TONE to output the test
tone.
The test tone is output in the following order
(depending on the speaker setting):
FL C
SW SL
If you don't hear a test tone from one of your
speakers, please refer to Speaker setting on
page 30 to make sure you have correctly
specified your speaker setup.
3 Press MASTER VOLUME +/– to adjust
the volume to an appropriate level.
4 Use LEVEL +/– to adjust the speaker
levels in turn.
You should hear the test tone at the same
volume from each speaker when seated in the
main listening position. The channel level range
is ± 10 dB.
5 When you're done, press TEST TONE to
turn off the test tone.
The speaker volume can be adjusted without
outputting the test tone by pressing CH
SELECT and then using LEVEL +/–.
• Test tone is only output in Standard
• Since the subwoofer transmits an ultra-low
FR
SR
modes.
frequency its sound may seem quieter
than it actually is.
STANDARD
MASTER
VOLUME
Î
06
33
En