Using The Tuner; Listening To The Radio; Improving Fm Stereo Sound - Pioneer VSX-D41 Operating Instructions Manual

07

Using the tuner

Listening to the radio

The following steps show you how to tune to FM
and AM radio broadcasts using the automatic
(search) and manual (step) tuning functions.
Once you are tuned to a station you can
memorize the frequency for recall later—see
Saving station presets on the next page for more
on how to do this.
1 Press the TUNER button on the remote
control to select the tuner.
You can also use the MULTI JOG/INPUT
SELECTOR dial on the front panel.
2 Use the BAND button to change the
band (FM or AM), if necessary.
Each press switches the band between FM and
AM.
3 Tune to a station.
There are three ways to do this:
Automatic tuning
To search for stations in the currently
selected band, press and hold the TUNING
+ / – buttons for about a second. The
receiver will start searching for the next
station, stopping when it has found one.
Repeat to search for other stations.
34
En
TUNER
TUNING
BAND MPX
Manual tuning
To change the frequency one step at a
time, press the TUNING +/– buttons.
High speed tuning
Press and hold the TUNING + / – buttons
for high speed tuning. Release the button
at the frequency you want.

Improving FM stereo sound

If the TUNED or STEREO indicators don't light
when tuning to an fm station because the
signal is weak, press the MPX button to switch
the receiver into mono reception mode. This
should improve the sound quality and allow you
to enjoy the broadcast.