Resetting The Main Unit; Cleaning The Unit; Specifications (Vsx-D414) - Pioneer D514 Operating Instructions Manual

09 Additional information

Resetting the main unit

Use this procedure to reset all the receiver's
settings to the factory default. Use the front
panel controls to do this.
1 Switch the receiver on.
While holding down the TONE button, press
and hold the
three seconds.
2 When you see RESET? appear in the
display, press the TONE button.
OK? shows in the display.
3 Press TONE once more to confirm.
OK appears in the display to indicate that the
receiver has been reset to the factory default
settings.

Cleaning the unit

• Use a polishing cloth or dry cloth to wipe
off dust and dirt.
• When the surface is dirty, wipe with a soft
cloth dipped in some neutral cleanser diluted
five or six times with water, and wrung out well,
and then wipe again with a dry cloth. Do not
use furniture wax or cleansers.
• Never use thinners, benzine, insecticide
sprays or other chemicals on or near this unit,
since these will corrode the surface.
44
En
STANDBY/ON button for about

Specifications (VSX-D414)

Amplifier Section
Continuous Power Output (Stereo RMS)
Front ........................................................... 120 W
Continuous Power Output (Surround RMS)
Front ...................................... 120 W per channel
Center .................. 120 W (1kHz, THD 10 %, 8 Ω)
Surround ............................... 120 W per channel
Input (Sensitivity/Impedance)
CD, DVR/VCR, CD-R/TAPE/MD,
DVD/LD, TV/SAT ........................... 200 mV/47 kΩ
Frequency Response
CD, DVR/VCR, CD-R/TAPE/MD, DVD/LD,
TV/SAT ........................... 5 Hz to 100,000 Hz dB
Output (Level/Impedance)
DVR/VCR REC, CD-R/TAPE/MD REC
...................................................... 200 mV/2.2 kΩ
Tone Control
BASS .......................................... ± 6 dB (100 Hz)
TREBLE ...................................... ± 6 dB (10 kHz)
LOUDNESS .... +6.5 dB/+3 dB (100 Hz/10 kHz)
Signal-to-Noise Ratio
(IHF, short circuited, A network)
CD, DVR/VCR, CD-R/TAPE/MD,
DVD/LD, TV/SAT ......................................... 96 dB
Signal-to Noise Ratio
[EIA, at 1 W (1 kHz)]
CD, DVR/VCR, CD-R/TAPE/MD,
DVD/LD, TV/SAT ......................................... 79 dB
(1 kHz, THD 0.2 %, 8 Ω)
(1kHz, THD 10 %, 8 Ω)
(1kHz, THD 10 %, 8 Ω)
+0
– 3
(at volume level –50 dB)