Using This Unit With A Pioneer Plasma Display; Sr+ Setup For Pioneer Plasma Displays - Pioneer S-X360 Operating Instructions Manual

Other connections
Using this unit with a Pioneer plasma
display
If you have a Pioneer plasma display
2
SR+ cable to connect it to this unit and take advantage
of various convenient features, such as controlling this
unit via the plasma display's remote sensor, automatic
video input switching of the plasma display, display unit
messages appearing on the plasma display screen, and
automatic volume muting on the plasma display.
Media receiver
CONTROL
OUT
ANTENNA
CONTROL IN
MCACC
SETUP MIC
FM
UNBAL
CONTROL SPEAKERS
DVD/DVR
SYSTEM CONNECTOR
OUT
SUB WOOFER R SURROUND L
(COAXIAL)
USE ONLY WITH
DISPLAY UNIT
CENTER R FRONT L
AC IN
Important
• With an SR+ cable connected, the remote must now
be pointed towards your plasma display rather than
the display unit of the receiver subwoofer in order to
control the receiver subwoofer.
• Use a 3-ringed miniplug SR+ cable to connect the
CONTROL IN jack of this unit (through a media
receiver, if applicable) to the CONTROL OUT jack of
3
your plasma display.
Before you can use the extra SR+ features, you need to
make a few settings in the unit—see SR+ Setup for
Pioneer plasma displays below.
Note
1 This system is compatible with all Pioneer plasma displays from 2003 onward.
2 The 3-ringed SR+ cable from Pioneer is commercially available under the part number ADE7095. Contact the Pioneer Customer Support division for
more information on obtaining an SR+ cable.
3 You won't be able to use the remote sensor of this unit with the CONTROL IN jack of this unit connected to the CONTROL OUT jack of your plasma
display. You can use the remote sensor of the plasma display (even in standby) as long as the power isn't switched off.
1
, you can use an
Pioneer plasma display
AM
75Ω LOOP ANTENNA
AUDIO INPUT
DIGITAL
XBOX 360 DIGITAL ANALOG
(OPTICAL) (OPTICAL)
L
R

SR+ Setup for Pioneer plasma displays

Make the following settings if you have connected a
Pioneer plasma display to this unit using an SR+ cable.
SET UP
1
ENTER
MCACC
7
SURROUND ADVANCED
0
+
INPUT CHANNEL
–
1 Press SR+.
2 Use the (cursor left/right) buttons to
choose SETUP, then press ENTER.
3 Use the (cursor left/right) buttons to
choose the setting you want to adjust.
The current setting is shown for each option as you cycle
through the display. See below for a full list and
description of each.
4 Use the (cursor up/down) buttons to adjust
the setting.
5 Repeat steps 3 and 4 to make other settings.
6 When you're done, press ENTER to leave the SR+
setup menu.
Automatic plasma display volume muting
When Volume Control is switched on, the volume of the
plasma display is automatically muted when the receiver
subwoofer is switched on, or the receiver subwoofer's
input function is changed to one that you would want to
hear the sound from the receiver subwoofer rather than
the plasma display (DVD, for example).
• VOL.C ON – When this unit is switched on, or the
input function is changed, the volume on the plasma
display is muted so only sound from this unit is
heard.
• VOL.C OFF – This unit does not control the volume of
the plasma display
TIMER REC REC MODE
+
SR ONE TOUCH COPY
MENU
TEST TONE VIDEO IN
9
SOUND
JUKE BOX
+
VOLUME DISPLAY
–
RDS DISP
AXD7442
08
27
En