When The Hard Disk Drive Is Disconnected; Route Setting Information; Route Search Specifications - Pioneer AVIC-Z1 Operation Manual

When the hard disk drive is dis-
connected
If there is no hard disk drive because of the repair
or service, you can operate Radio source only
without the hard disk drive.
Only following operation is available. Other func-
tions can not operate.
• Only FM, AM source can operate. (Preset sta-
tion select and can not operate.)
• If the selected source before ejecting the hard
disk drive is [AV]. [AV input] source is avail-
able on "Rear display". (If the selected source
is [DVD], nothing is output to "Rear display". If
the selected source is [MIRROR], Same
image as "Front display" is output to "Rear dis-
play".)
• Rear view camera is available only when the
vehicle is backing up. ([Rear View] is not
available.)
194

Route Setting Information

Route search specifications

Your navigation system sets a route to your desti-
nation by applying certain built-in rules to the
map data. This section provides some useful
information about how a route is set.
• When a route is calculated, the route and
voice guidance for the route is automati-
cally set. Also, for day or time traffic regu-
lations, only information about traffic
regulations at the time when the route was
calculated is shown. One-way streets and
street closures may not be taken into con-
sideration. For example, if a street is open
during the morning only, but you arrive
later, it would be against the traffic regula-
tions so you cannot drive along the set
route. When driving, please follow the
actual traffic signs. Also, the system may
not know some traffic regulations.
• The calculated route is one example of the
route to your destination decided by the navi-
gation system whilst taking the type of streets
or traffic regulations into account. It is not nec-
essarily an optimum route. (In some cases, you
may not be able to set the streets you want to
pass. If you need to pass a certain street, set
the waypoint on that street.)
• The route set by your navigation system may
not use the streets known to local drivers, such
as small streets or special roads.
• Some route options may become the same
route. If waypoints are set, only one route is
calculated.
• If the destination is too far, there may be
instances where the route cannot be set. (If
you want to set a long-distance route going
across several areas, set waypoints along the
way.)
• During voice guidance, turns and intersections
from the freeway are announced. However, if
you pass intersections, turns, and other guide
points in rapid succession, some may not be
announced.
• It is possible that guidance may direct you off a
freeway and then back on again.