Displaying And Maintaining An Irf Fabric; Configuration Examples; Lacp Mad-Enabled Irf Configuration Example - HP FlexFabric 12900 Series Configuration Manual

To manually recover an inactive IRF fabric:
Step
1. Enter system view.
2. Recover the inactive IRF fabric.
After the IRF fabric is recovered, all ports that have been shut down by MAD come up automatically.

Displaying and maintaining an IRF fabric

Execute display commands in any view.
Task
Display information about all IRF members.
Display the IRF fabric topology.
Display IRF link information.
Display basic IRF settings.
Display the load sharing mode for IRF links.
Display MAD configuration.

Configuration examples

This section provides IRF configuration examples for two-chassis IRF fabrics that use different MAD
mechanisms.

LACP MAD-enabled IRF configuration example

Network requirements
As shown in
Configure LACP MAD on the multichassis aggregation to Device C, an HP device that supports extended
LACP.
Figure 12, set up a two-chassis IRF fabric at the access layer of the enterprise network.
Command
system-view
mad restore
Command
display irf
display irf topology
display irf link
display irf configuration
display irf-port load-sharing mode [ irf-port
[ member-id/port-number ] ]
display mad [ verbose ]
33